|
Getting Started
|
|
Design and Circuit Requirements
|
|
Emtron Hybrids will review your circuit as to the potential to meet the electrical and mechanical requirements necessary to create your custom hybrid circuit. Certain information would be required, such as.
 |
Schematic diagram including packaging configuration, size and required pin outs.
|
|
Component values, tolerances and power dissipation
|
|
Component parameters and matching requirements
|
|
Environmental and reliability constraints
|
|
Packaging and end use requirements such as hermeticity and solderability
|
|
Priorities and. trade offs, for example, performance vs. size vs. costs, etc…
|
|
|
Design Engineering included with Hybrid Layout
|
|
Emtron Hybrids will work with you to layout your circuit to achieve a design that keeps manufacturability mind into a thick film hybrid layouts is key to cost effective reliable circuit. Electrical, mechanical, manufacturing and quality engineering disciplines are combined to insure process reliability and repeatability with complete documentation allowing full traceability.
|
|
Consultation - Circuit Design
|
|
Layout created and Substrate drawing prepared
|
|
Customer layout checked for accuracy and ability to be produced
|
|
Resistor trim and Process specifications checked and/or created
|
|
Final mechanical and electrical test specifications and procedures defined
|
|
Product flow chart generated with in-process test procedures specified, including resistor trimming requirements
|
|
Customer approval requested
|
|
Computerized artwork generated
|
|
Artwork photoplotted
|
|
Screens created
|
|
Tooling and Fixtures ordered
|
|
Multilayer architecture
|
|
Radio Frequency (RF) and microwave
|
|
Mixed signal
|
|
Thick signal
|
|
Thermal and industrial packaging
|
|
Component and subassembly analysis
|
|
|
Phone 631-924-9668 Fax 631-924-0637 Email: Info@emtronhybrids.com
|